Electric bicycles are becoming more popular these days. And because of the continuous increase in prices of gasoline and worsening polluton and traffic congestion, people are starting to choose better modes of tranportation to take them to different places they have to be. Most of them like something that is very convenient, at the same time something that will allow them to save some cash. This is where electric bicycles come into play.
What’s great about electric bicycles is how easy they are to own. Buying a new one is way cheaper than buying a new car or a traditional motorcycle. However, if you can build one, you can definitely save more money. And building an electric bike is super easy. You just have to start with an old bike and an electric bicycle kit. And by following this simple guide, you will definitely be riding your own eBike in no time.
1. To start, you need to find out if your bike is the type that can be converted into an electric bicycle. You can refer to your conversion kit manual to find out if you can really turn your old bike into an eBike. You also need to determine if your electric motor can fit to your bike.
2. Once you figure out those important things, you now need strip the bike down and remove all the unnecessary accessories. You have to bring it down to its bare minimum.
3. Next, you have to remove the front wheel of your bike. Do this by turning the bike upside down, then releasing all the air from the tire. You then have to unscrew the axle nuts of the wheel to completely remove it from the frame. In doing this, make sure that you don’t damage the brakes of the bike.
4. Once the wheel is removed, you now have to install the new front wheel that comes with the conversion kit. This wheel will have wires that attach to the battery pack of the electric motor. Because of this, you have to properly attach the wheel to the frame so that the wires won’t be on the way. To learn how to properly do this, you can always refer to the manual. It will tell you which side to of the bike the wires need to exit from. This is because some conversion kits have them on the left, while some are on the right. After figuring this out, you then have to secure the wheel properly by tightening the axle bolts by using a wrench. If necessary, adjust the brake so they work properly.
5. After that, you have to mount the battery pack. Where you put thm may vary depending on the model type of your conversion kit. But most battery packs for electric motor kits use the rear axle and seat clamp as support.
6. After mounting the battery pack in its proper place, you now have to install the controllers. Though there are some variations on this part of the kit, they usually go below the handlebars or under the seat rack. Use zip ties or bungee cables to install the controller properly.
7. Then you have to install the throttle by removing the right handlebar grip. You just have to slide the throttle over the handlebar and tighten them using a wrench.
8. After that, you now need to run the wires and connect them to the motor and controllers. You shouls also connect them to the throttle. Refer to the manual to ensure that all wirings are on their proper places. Tame the wires using zip ties so they are not in the way for when you are riding the bike. Finally, you can connect the wires to the batteries to complete the circuit.
9. To ensure everything is in their proper places, test the ignition of the motor. If you follow all the steps properly, you will start riding your electric bike in no time.
To learn more about electric bicycle motors and their many different benefits, visit http://electricbicyclemotors.org today!